Get In Touch

Contact Us

Get in touch through the form below.



  • SBL1050EFT machine


Reference: 123


Automatic Foil Stamping and Die-Cutting Platen With TRANSVERSE FOIL PULL

Maximum Sheet Size 1050mm x 750mm
Minimum Sheet Size 400mm x 370mm
With Small Sheet Device (Option) 350mm x 300mm
Maximum Die-Cutting Paper Size 1040mm x 730mm
Minimum Gripper Margin 9.5mm
Die-Cutting Output Force 300ton
Inner Size of Cutting Chase 1144mm x 760mm
Lower Cutting Plate Size 1080mm x 736mm
Material Handling Range

0.1mm - 2mm

80gsm - 1400gsm

Corrugated Board Range < 4mm
Recommended Cutting Rule Height 23.60mm
Maximum Cycle Speed 8,000cph
Maximum Operating Speed 7,500sph
Maximum Foil Stamping Speed 7,000sph
Registration Tolerance +0.075mm
Power Requirement - Main Machine 20KvA
Power Requirement - Foil Stamping 35KvA
Machine Outer Dimensions

L - 5573mm / W - 2801mm / H - 2623mm

Approximate Weight 19.5ton
Feeder Pile Height (with pallet) 1200mm
Feeder Pile Height (with non stop system) 1400mm
Delivery Pile Height 1040mm
Standard Number of Longitudinal Foil Shafts 3
Rewind Shafts 6 (8 is optional)
Maximum Foil Diameter (including core) 240mm
Maximum Foil Rewind Diameter 400mm
Maximum Foil Width 1000mm
Transverse Foil Shafts 2
Transverse Rewind Shafts 2
Maximum Foil Diameter (including core) - Transverse 200mm
Maximum Foil Rewind Diameter - Transverse 200mm
Number of Heating Zones 20
Hologram Feature Optional



  1. Full colour touch screen HMI. This self-diagnostic system is easy to operate and helpful for troubleshooting any problems throughout each section of the machine.
  2. Updated and upgraded foil control system, via full colour touch screen HMI.  All foil drives have updated, now servo driven on all foil drive shafts, giving improved foil pull accuracy, even at high speed.
  3. Anvil mounted, 20-zone heater plate, to accurately disperse heat throughout the honeycomb chase, reducing any chance of ‘cool zones’.
  4. HMI controlled automatic on/off impression system, with tonnage searching program set at low point to avoid machine and foiling die damage.  Maximum 300 ton of pressure for both foil stamping and die-cutting.
  5. Able to run a wide range of stock, from thin paper to B-flute corrugated.
  6. Sheet transport to front lays monitored and controlled by photoelectric sensors.
  7. Standard equipment includes operator and drive side push/pull side lay, monitored by micro photoelectric sensors.
  8. High strength alloy gripper bars to ensure stability at high running speed.
  9. Pneumatic honeycomb and cutting plate locking system to eliminate loose mechanical parts.
  10. Standard equipment includes operator and drive side push/pull side lay, with micro photoelectric sensors
  11. Non-stop feature in both Feeder and Delivery section.
  12. Pneumatic side joggers, controlled with machine timing, which provides easy adjustment and stable paper stack in delivery, throughout the range of stock and paper size.
  13. Options Available;
    1. 2-6 hologram reader system.
    2. Brush rewinding device.
    3. Pre make-ready table (with modified footprint)
    4. Small sheet device
  14. Full CE safety accreditation.

Your Enquiry get in touch